DRIVE GP-ACCESSORY 8N9653 - Caterpillar

performing any operation or maintenance procedures, ensure that the Safety Information, warnings, and instructions are read and understood.To determine the maintenance intervals, use fuel consumption, service hours, or calendar time, which ever occurs first.Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must be performed.Refer to the Operation and Maintenance Manual, "SR4B Generators and Control Panels" for all maintenance information for generators.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Enclosure - Inspect
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Replace
Fuel System - Prime
Severe Service Application - Check
Trailer - Inspect
Daily
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Every Week
Battery Charger - Check
Instrument Panel - Inspect
First 9500 L (2500 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or 1 Month
Fuel System Secondary Filter - Replace
Every 9500 L (2500 US gal) of Fuel or 250 Service Hours or Yearly
Aftercooler Core - Clean/Test
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Engine - Clean
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Magnetic Pickups - Clean/Inspect
Radiator - Clean
Every 19 000 L (5000 US gal) of Fuel or 500 Service Hours or 3 Months
Fuel System Primary Filter/Water Separator Element - Replace
Every 114 000 L (30 000 US gal) of Fuel or 3000 Service Hours or 3 Years
Alternator - Inspect
Cooling System Coolant (DEAC) - Change
Cooling System Coolant Extender (ELC) - Add
Cooling System Water Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Electronic Unit Injector - Inspect/Adjust
Engine Mounts - Inspect
Engine Speed/Timing Sensors - Check/Clean/Calibrate
Engine Valve Lash - Inspect/Adjust
Engine Valve Rotators - Inspect
Starting Motor - Inspect
Turbocharger - Inspect
Water Pump - Inspect
Every 228 000 L (60 000 US gal) of Fuel or 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Standby Generator Set Maintenance Recommendations
Overhaul
Overhaul Considerations