AVSPARE.COM
parts catalog

DRIVER-SEAL 1400163 - Caterpillar



1400163 DRIVER-SEAL Caterpillar parts DRIVER
Rating:
36
Alternative (cross code) number:
CA1400163
140-0163
1400163
Caterpillar 1400163 DRIVER-SEAL
Weight: 2 pounds 1 kg.

Buy DRIVER-SEAL 1400163 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

START BY:a) remove centershift lock 1. Lower the blade to the ground.2. Fasten a hoist to blade centershift cylinder (8). Remove cap (7), the shims and the insert and shims from the cap. Lower the blade centershift cylinder down on to the circle drawbar. Remove the insert from the rod end of the cylinder.3. Remove the bolt and clip (6) from the lift bar.4. Fasten a hoist to the lift bar.5. Remove bolts (1) and lock (5) from each end of the lift bar. Remove pins (2) and (4). Remove the washers from between the lift arm and the lift bar.6. Remove blade lift bar (3). Weight is 360 lb. (163 kg). Move the lift bar out toward the rear of the machine. Lower it to the ground. Move the hoist free of the frame. Remove the lift bar out the side of the machine. 7. Remove the lip type seals from both ends of the blade lift bar. Use tooling (A) to remove the bearings from the ends of the blade lift bar. 8. Remove lip type seal (9) and snap ring (10) from the bore of the blade lift bar. Remove two bearings (11) and the spacer between them with tooling (B).Install Blade Lift Bar
Do not use an impact type driver to install bearings (1).
1. Install new bearings (1) in each end of the blade lift bar with tooling (A). Install the bearings to depth of .344 .016 in. (8.74 0.41 mm) from the outside surfaces of the lift bar.2. Install the four new seals in each end of the lift bar with tooling (B). Install with the lip of the seals toward the outside of the bore as shown. Install the seals even with the outside surfaces of the lift bar. 3. Install the snap ring in the bore of the blade lift bar. Lower the temperature of the two bearings. Use tooling (C) as shown to install the first bearing in the bore so it is against the snap ring in the bore. Install the spacer so it is against the first bearing. Use tooling (C) to install the second bearing so it is against the spacer. 4. Use tooling (B) to install lip type seal (2) with the lip out as shown. Install the seal so it is against the snap ring. 5. Fasten a hoist to blade lift bar (3). Put the blade lift bar in position on blade lift arms (4). The weight of the blade lift bar is approximately 360 lb. (163 kg).6. Install the washers between the blade lift bar and the blade lift arm. Install enough washers so that the distance between face (5) on the blade lift bar and lock plate (6) is .090 .030 in. (2.29 0.76 mm). 7. Install pins (8) and (9) to hold blade lift bar (3) in position. Make sure the groove (slot) in the pin is in alignment with the groove (slot) in the blade lift arms.8.


Parts driver Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.