DRUM AS 2606411 - Caterpillar

Table 1
Programming parameters that are available for machines that are equipped with One Way / Two Pump Flow (1)    
Message Center (Line 3)    Default Values (Line 4)    Range of Values    Increment    Description of Parameter    
           
"TOOL#1-001"     "0"             This is the default name of "TOOL#1". The default name can be changed. Be sure to use a good descriptive name.    
"TOOL#1-002"     "10"             Parameter 002 is Enabled when parameter 003 is ON.
When Parameter 002 is Enabled and the value of the engine speed dial indicator is Greater than the value of Parameter 002, the engine speed is determined by the value of Parameter 002 when the work tool is activated.
When Parameter 002 is Enabled and the value of the engine speed dial indicator is Less than the value of Parameter 002, the engine speed is determined by the value of the engine speed dial indicator when the work tool is activated.
Parameter 002 is Disabled when Parameter 003 is OFF.
When Parameter 002 is Disabled, the engine speed is determined by the value of the engine speed dial indicator.    
"TOOL#1-003"     "ON"             When Parameter 003 is ON, Parameter 002 is Enabled.
When Parameter 003 is OFF, Parameter 002 is Disabled.    
"TOOL#1-004"     "ENABLED"             "ENABLED" means that the controller maintains the target rpm. "DISABLED" means that the controller provides a constant torque to the pump. Constant torque is used primarily for applications with a magnet. A constant torque maintains a constant rpm for the engine and the generator.    
"TOOL#1-005"     "ENABLED"             "ENABLED" means 2 pump flow. "DISABLED" means 1 pump flow.    
"TOOL#1-101"     "95"    
0 to 400 L/min (0 to 105 US gpm)    
5 L/min (1.3 US gpm)     This is the flow that is required to operate a specific work tool. This value is specified by the manufacturer of the work tool.    
"TOOL#1-102"     "0"    
0 to 400 L/min (0 to 105 US gpm)    
5 L/min (1.3 US gpm)     Use caution when this parameter is set. The excess flow that is not required by the additional operation will be diverted to the work tool. Possible damage to the work tool can result.
Parameter 102 is the additional flow from the pumps when another control valve on the main control valve shifts during the operation of the work tool. The additional flow enables the work tool to operate at a constant flow during the operation of the other functions.    
"TOOL#1-103"     "17000"    
0 to 40000 kPa (0 to 5800 psi)    
100 kPa (14.5 psi)     This is the desired operating pressure for the specific work tool. This value is the operating pressure for the tool plus 2000 kPa. This method is used in order to account for line losses. The