EDGE-END 1004044 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Several different types of air cleaners are available. The following procedures describe the removal and installation of a typical air cleaner.
Illustration 1 g01055403
Loosen clamps (1). Remove cover (23) and the seal for the cover. Note: For information on servicing the air cleaner elements, Refer to the Operation and Maintenance Manual for the engine that is being serviced.
Remove the air cleaner element.
Loosen clamp (2).
Disconnect harness assembly (4).
Attach a lifting device to air cleaner housing (5). The weight of air cleaner housing (5) is approximately 27 kg (60 lb).
Remove bolts and washers (6) that attach air cleaner housing (5) to the bracket.
Remove air cleaner housing (5). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01055403
Attach a suitable lifting device to air cleaner housing (5). The weight of air cleaner housing (5) is approximately 27 kg (60 lb).
Position air cleaner housing (5) on the air inlet of the turbocharger. Install bolts and washers (6) that attach air cleaner housing (5) to the bracket.
Install clamp (2).
Connect harness assembly (4). Note: Before you install the air cleaner element, inspect the air cleaner element for cleanliness and good condition.
Install the air cleaner element.
Inspect the seal of cover (3) for cleanliness and good condition. Install cover (3) with the seal. Fasten clamps (1).