EDGE-SEGMENT 1073536 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     9U-6238     Guide Bolt     2    
B     8T-3052     Degree Wheel     1    
Thoroughly clean the top of the cylinder block and the bottom of the cylinder head. Ensure that there is no debris in the cylinder bores.
Illustration 1 g00550165
Typical example
Place cylinder head gasket (3) on dowels (4) on top of the cylinder block. The cylinder head gasket (3) is stamped "FRONT TOP". Do not use any sealant or compound on the cylinder head gasket.
Install Tool (A) in positions 15 and 20 in the cylinder block. Refer to Illustration 5.
Illustration 2 g00550163
Typical example
Attach a suitable lifting device to cylinder head (2) .
Place cylinder head (2) on the cylinder block. Ensure that the cylinder head is positioned on dowels (4) and that cylinder head gasket (3) is positioned correctly.
Remove Tool (A) .
Illustration 3 g00550160
3054 Engine
Illustration 4 g00572265
3056 Engine
Lubricate cylinder head bolts (1) with clean engine oil.
Illustration 5 g00550162
3054 Engine
Illustration 6 g00572255
3056 Engine
Gradually tighten all of the bolts in a numerical sequence to a torque of 110 N m (80 lb ft).
Tighten all of the bolts again in a numerical sequence to a torque of 110 N m (80 lb ft).
Place an index mark on the bolts and use Tool (B) in order to further tighten the bolts.
Turn the short bolts that are marked with an "S" for an additional 150 degrees (2.5 flats).
Turn the medium length bolts that are marked with an "M" for an additional 180 degrees (3.0 flats).
Turn the long bolts that are marked with an "L" for an additional 210 degrees (3.5 flats).Note: Refer to the Testing and Adjusting Module, "Cylinder Compression" for the correct procedure to test the cylinder head.End By:
Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Install the water outlet manifold. Refer to Disassembly and Assembly, "Water Outlet Manifold - Install".
Install the exhaust manifold. Refer to Disassembly and Assembly, "Exhaust Manifold - Remove and Install".
Install the air inlet manifold. Refer to Disassembly and Assembly, "Air Inlet Manifold - Install".
Install the fuel injection nozzles. Refer to Disassembly and Assembly, "Fuel Injection Nozzles - Install".