EDGE-CUTTING 1099122 - Caterpillar

Installation Procedure
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00592341
Place motor (13) onto fan guard (14) .
Install two bolts (15). Install three fittings (12) .
Rotate fan drive assembly to the other side.
Illustration 2 g00769128
Install adapter (11) onto the shaft of the gear motor.
Adapter (11) can only be mounted in one position. Check adapter (11) for wear.
Illustration 3 g00769100
Place fan (8) on adapter (11). Install four bolts (9). Install bolt (10) to a torque of 30 7 N m (22 5 lb ft).
Illustration 4 g00769090
Place fan drive assembly (7) in position. Install four bolts (6) to a torque of 30 7 N m (22 5 lb ft).
Illustration 5 g00769086
Install hydraulic lines (5), (4) and (3) .
Illustration 6 g00769079
Install hydraulic lines (2) and (1) .
Check the hydraulic oil level. If the hydraulic oil level is low, add hydraulic oil to the hydraulic tank. Refer to Operation and Maintenance Manual, SEBU7468, "Hydraulic System Oil Level - Check" for the proper procedure.
Start the engine and check for leaks.
Close the engine access door.