EDGE-SEGMENT RH 1133141 - Caterpillar

Illustration 1 g00955937
The "type 1" pin that is in the unlocked position (2) and the locked position (1).
Illustration 2 g00955964
The "type 2" pin that is in the unlocked position (1) and the locked position (2).
Put the fork tines in the Unlocked position. Space the fork tines as far as possible from each other.
Put the fork tines in the Locked position.
Slowly, move the machine into position and engage the load. The machine should be square with the load. Space the forks evenly between the pallet stringers.
Move the machine forward until the load contacts the carriage.
Lift and lower the load carefully.
Carefully lower the load while you tilt the forks back to the travel position.Travel with the load as low as possible while you still maintain ground clearance.Travel with the load uphill on upgrades and on downgrades.Pallet Fork Tines Installation
Illustration 3 g06338700
Illustration 4 g06338773
Place the lift arms fully down and adjust the coupler tilt until the front face of the fork carriage assembly is vertical.
On the tine, unlock the pin (1).
Assemble the tine at the center of the carriage by resting the top hook of the tine (2) on the upper carriage rail (3) and pass the bottom hook (4) through the clearance notch in the lower carriage rail (5). If the tine is touching the ground, raise the carriage slightly.
Move the tine to either side until the bottom hook contacts the lower carriage rail.
Move the tine to the desired position by applying side force, alternating between the top or bottom of the tine.
Once close to the desired position, lock the pin on the tine (1) and continue moving the tine until the pin locks down into one of the upper carriage rail notches.
Adjust the tine as needed to confirm it is in a vertical position from the front and side views.
Repeat steps 2-7 for the second tine.