1285379 EDGE AS Caterpillar parts
322B L, 322C, 325B L, 325C, 330B, 330B L, 330C L
Rating:
Alternative (cross code) number:
CA1285379
128-5379
1285379
CA1285379
128-5379
1285379
Weight: 904 pounds 410 kg.
EXCAVATOR,
Compatible equipment models: 1285379:
Number on catalog scheme:
4
For full view, you need register
Information:
Table 1
Diagnostic Trouble Codes
CDL Code Code Description
(code descriptions may vary) Comments
100-13 Engine Oil Pressure Sensor : Out of Calibration During key on, the signal voltage from the engine oil pressure sensor indicated an engine oil pressure greater than +/- 54 kPa (8 psi) from the atmospheric pressure sensor.
Reference sensor : Atmospheric Pressure Sensor
101-13 Crankcase Air Pressure Sensor : Out of Calibration During key on, the signal voltage from the crankcase air pressure sensor indicated a crankcase air pressure greater than +/- 1.5 kPa (0.2 psi).
There is not a reference sensor for this sensor
274-13 Atmospheric Pressure Sensor : Out of Calibration During key on, the signal voltage from the atmospheric pressure sensor indicated an atmospheric pressure other than 0 kPa (0 psi).
This sensor is used as a reference sensor
1785-13 Intake Manifold Pressure Sensor : Out of Calibration During key on, the signal voltage from the Intake Manifold pressure sensor indicated an Intake Manifold pressure greater than +/- 18 kPa (3 psi) from the Atmospheric Pressure sensor.
Reference sensor : Atmospheric Pressure Sensor
Table 2
Troubleshooting Test Steps Values Results
1. Check for Diagnostic Trouble Codes
The engine coolant temperature must be greater than 0° C (32° F) before beginning this procedure.
A. Establish communication between Cat® Electronic Technician (ET) and the Electronic Control Module (ECM) . Refer to Troubleshooting, "Electronic Service Tools", if necessary.
B. Download the "Warranty Report" from the engine ECM before performing any troubleshooting or clearing diagnostic trouble codes.
C. Wait at least 30 seconds in order for the diagnostic codes to become active.
Look for an active -13 code or for a logged -13 code.
Diagnostic Trouble Codes
Result: There is an active or there is a logged -13 code.
Proceed to Test Step 2.
2. Check for Debris
A. Turn the keyswitch to the OFF position.
B. Check the suspect sensor for debris.
C. If applicable, check the reference sensor for debris.
D. Check the sensor measurement port for blockage by debris.
E. If debris is found, clear the debris from the measurement port and replace the suspect sensor.
F. Turn the keyswitch to the ON position.
G. Check for -13 codes. Wait at least 30 seconds in order for the diagnostic codes to become active.
Debris
Result: The sensor measurement port is not blocked by debris.
Proceed to Test Step 3.
Result: A -13 code is present, replace the suspect sensor. Verify that the problem is resolved.
Result: If more than one -13 code is present and the codes have a reference sensor, replace the reference sensor. Verify that the problem is resolved.
3. Inspect the Suspect Sensor Connector
A. Turn the keyswitch to the OFF position.
Inspect the suspect sensor connector for moisture and/or corrosion.
Moisture
Result: The suspect sensor connector has moisture and/or corrosion.
Proceed to Test Step 4.
Result: The suspect sensor connector does not have moisture and/or corrosion.
Proceed to Test Step 5.
4. Remove any moisture and/or corrosion
A. Disconnect the suspect sensor connector.
B. Remove any moisture and/or corrosion from the outside of the connector. Check for moisture and corrosion inside the connector. Verify that the seals for the wires are sealing correctly. Refer to Troubleshooting, "Electrical Connectors - Inspect", if necessary.
C. If
Caterpillar parts catalog:
Parts edge Caterpillar catalog:
1042097
EDGE AS
318B, 318C, 320, 320 L, 320B, 320C, 320D LRR, 320D RR, 322 FM L, 322B L, 322C, 325, 325B L
318B, 318C, 320, 320 L, 320B, 320C, 320D LRR, 320D RR, 322 FM L, 322B L, 322C, 325, 325B L
311C, 311D LRR, 311F LRR, 312C L, 312D, 314C, 314D LCR, 315C, 315D L, 320C, 322C, 325B L, D6E, D6E SR, D6G, D6G SR, D6G2 XL, D6T XL
315C, 320C, 322C, 325B L, 924G, 924GZ, 924H, 924K, 928HZ, 930G, 930K, 938K
2765881
EDGE AS
320C, 320D, 322B L, 322C, 324D L
320C, 320D, 322B L, 322C, 324D L
7Y6601
EDGE
320 L, 320B, 320C, 320C L, 320D, 320D L, 320E, 320E L, 320E LN, 320N, 322B, 322B L, 322C, 324D, 324D L, 324E, 324E L, 324E LN, 325, 325 LN, 325D L, 329D, 329D L, 329E, 329E L, 330B L
320 L, 320B, 320C, 320C L, 320D, 320D L, 320E, 320E L, 320E LN, 320N, 322B, 322B L, 322C, 324D, 324D L, 324E, 324E L, 324E LN, 325, 325 LN, 325D L, 329D, 329D L, 329E, 329E L, 330B L
2322924
EDGE
322B L, 322C, 324D, 324D L, 325B L, 325C, 325D L, 329D L, 330B L, 330C L, 330D L, 336D L, 336E L
322B L, 322C, 324D, 324D L, 325B L, 325C, 325D L, 329D L, 330B L, 330C L, 330D L, 336D L, 336E L
1282954
EDGE AS
322B L, 322C, 325B L, 325C, 330B L, 330C L
322B L, 322C, 325B L, 325C, 330B L, 330C L
1328418
EDGE AS
322 FM L, 322B L, 322C, 325B L, 325C, 330, 330 FM L, 330B L
322 FM L, 322B L, 322C, 325B L, 325C, 330, 330 FM L, 330B L
2416729
EDGE AS
320C, 322B L, 322C
320C, 322B L, 322C
1178975
EDGE AS
322B L, 322C, 325, 325B L, 325C, 330, 330B L, 330C, 330C L
322B L, 322C, 325, 325B L, 325C, 330, 330B L, 330C, 330C L
1233220
EDGE AS
322B L, 322C, 325, 325B L, 325C, 330, 330B, 330B L, 330C L
322B L, 322C, 325, 325B L, 325C, 330, 330B, 330B L, 330C L
1052533
EDGE AS
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
1272304
EDGE AS
320C, 322 FM L, 322B L, 322C, 325, 325B L, 325C, 330, 330B L
320C, 322 FM L, 322B L, 322C, 325, 325B L, 325C, 330, 330B L
1272289
EDGE AS
320B, 320C, 320D2, 322 FM L, 322B L, 322B LN, 322C, 323D L, 323D2 L, 324D, 324D L, 324E, 324E L, 324E LN, 325, 325B L, 325C, 325D, 326D L, 329D, 329D L, 329E, 330, 330B L
320B, 320C, 320D2, 322 FM L, 322B L, 322B LN, 322C, 323D L, 323D2 L, 324D, 324D L, 324E, 324E L, 324E LN, 325, 325B L, 325C, 325D, 326D L, 329D, 329D L, 329E, 330, 330B L
1263718
EDGE AS
320B, 320C, 322 FM L, 322B L, 322C, 325, 325B L, 325C, 325D, 330, 330 FM L, 330B L
320B, 320C, 322 FM L, 322B L, 322C, 325, 325B L, 325C, 325D, 330, 330 FM L, 330B L
1052532
EDGE AS
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
1272296
EDGE AS
320B, 320C, 322 FM L, 322B L, 322B LN, 322C, 325, 325B L, 325C, 330, 330B L
320B, 320C, 322 FM L, 322B L, 322B LN, 322C, 325, 325B L, 325C, 330, 330B L
1379527
EDGE
322B L, 325, 325B L
322B L, 325, 325B L
1045748
EDGE AS
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
322B L, 322C, 325, 325B L, 325C, 330, 330 FM L, 330B L, 330C L
6I5224
EDGE AS
322B L, 322C, 325, 325 L, 325 LN, 325B L, 325C, 330, 330 FM L, 330B L, 330C, 330C L
322B L, 322C, 325, 325 L, 325 LN, 325B L, 325C, 330, 330 FM L, 330B L, 330C, 330C L
1045749
EDGE AS
322B L, 325B L, 330, 330 FM L, 330B L
322B L, 325B L, 330, 330 FM L, 330B L