EDGE-SEGMENT 1359295 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Thoroughly clean the top of the cylinder block and the bottom of the cylinder head. Ensure that there is no debris in the cylinder bores.Note: A number with four digits is stamped on the gasket in order to ensure the correct positioning of the gasket. This number faces the cylinder head. Make sure that the cylinder head is the correct thickness before installation.
Place the cylinder head gasket on the dowels on the top of the cylinder block. Do not use any gasket sealant or compound on the cylinder head gasket.
Illustration 1 g00597552
Attach a suitable lifting device to cylinder head (7) .
Place cylinder head (7) on the cylinder block. Ensure that the cylinder head is positioned on the dowels and that the cylinder head gasket is positioned correctly.
Lubricate the cylinder head bolts with clean engine oil.
Illustration 2 g00454966
Bolt tightening sequence for 3 cylinder enginesThe arrow points toward the front of the engine.
Illustration 3 g00597449
Bolt tightening sequence for 4 cylinder enginesThe arrow points toward the front of the engine.
Install the cylinder head bolts and gradually tighten the cylinder head bolts in a numerical sequence. The numerical sequence is shown in Illustration 2 and in Illustration 3. Tighten the cylinder head bolts to the following torque: 3003 Engine ... 51 N m (38 lb ft) 3013, 3014, and 3024 Engines ... 100 N m (74 lb ft)
Illustration 4 g00597219
Position external oil line (5) on the side of the engine and install bolt (6) .
Illustration 5 g00597210
Install bolt (4) and the two washers that fasten external oil line (5) to the front of the cylinder head.
Illustration 6 g00597200
Install nut (3) (not shown) that connects the external oil line to the fuel injection pump.
Install fuel hose (2) on the fuel injection pump and tighten hose clamp (1) .End By:
On 3013, 3014, and 3024 engines, install the inlet manifold. Refer to Disassembly and Assembly, "Inlet Manifold - Install".
On 3013 engines, install the water temperature regulator housing. Refer to Disassembly and Assembly, "Water Temperature Regulator Housing - Remove and Install".
On 3003 engines, install the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Install".
On 3003 engines, install the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Install".
Install the fuel injection nozzles. Refer to Disassembly and Assembly, "Fuel Injection Nozzles - Install".
Install the rocker shaft and the pushrods. Refer to Disassembly and Assembly, "Rocker Shaft and Pushrod - Install".
Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Install the exhaust manifold. Refer to Disassembly and Assembly, "Exhaust Manifold - Remove and Install".
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".