EDGE GP-CUTTING 1359387 - Caterpillar

This is a 1.0-hour job
If there has been a previous repair, part age/hours will apply. Retain a copy of the previous repair invoice in the dealer's records for audit purposes, and specify repair date and machine hours in the "Additional Comments" section of the warranty claim.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
COPY OF OWNER NOTIFICATION FOR JAPANESE OWNERS
XYZ Corporation
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR REPLACING FUEL FILTER BASE
MODELS INVOLVED - 910H WHEEL-TYPE LOADERS
Dear Cat Product Owner:
The existing filter base can possibly lead to fuel leakage on the products listed below. The fuel filter base will need to be replace with an improved 3437104/">343-7104 Fuel Filter Assembly. You will not be charged for the service performed.
Contact your local Cat dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
Please refer the dealer to their Service Letter dated 18Feb2013 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 18Feb2013 Service Letter
Rework Procedure
Image1.1.1
Image1.1.2
Removal of Existing Filter Base
Refer to Image1.2.1.
1. Remove existing sensor and boost tube.
2. Remove the sensor connector. The sensor connector will be reused after replacing 199-9252 O-Ring Seal.
Image1.2.1
3. Remove fuel lines from filter base.
4. Remove two bolts. Retain these bolts for later reuse.
5. Remove the filter base and the spacer. The spacers will not be reused.
Refer to Image1.3.1 and 1.3.2.
Image1.3.1
Image1.3.2
Installation of New Filter Base Assembly
Refer to Image1.4.1.
1. Install new 3437104/">343-7104 Filter Assembly.
2. Replace the short bolt with 6I-0260. Reuse another bolt with existing bolt.
3. Tighten all bolts to a specified torque of 28 N.m.
Note: Cover the open fuel port during installation.
Image1.4.1
4. Install the existing sensor connector and tighten to a specified torque of 20 N.m. Replace the 199-9252 O-Ring Seal of the connector when installing.
5. Install the 067-6264 Fitting and 067-6265 Olive to both sides of the 305-0659 Boost Tube. Refer to Image1.5.1.
6. Install the boost tube and tighten to a specified torque of 8 N.m. Refer to Imagae1.5.2.
Note: Use seal tape to each thread, as needed.
Image1.5.1
Image1.5.2
7. Assemble the fuel line and boost sensor. Refer to Image1.6.1.
Image1.6.1