EDGE-SEGMENT 1406866 - Caterpillar

Custom 4UP Display
The Custom 4UP Display feature allows the user to customize the organization of the aftertreatment parameters on the 4 Up display.Note: There can be up to TWO total custom 4up screens (8 total parameters).
From the main menu screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector is in the "Display Settings" category.
Press the ENTER button (button 5) to enter the "Display Settings" Menu.
From the Display Settings screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector is in the "Custom 4Up Display" category.
Press the ENTER button (button 5).
From this screen, use the UP and DOWN button (button 1) to move the selector triangle through each one of the four displayed aftertreatment parameters.
Use the UP and DOWN buttons (button 6) to cycle through the different options of possible aftertreatment parameters that can be displayed.
Use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to see the next 4 aftertreatment parameters to customize.
Press the LIST button (button 2) to save your changes and return to the 4Up setup menu.
Illustration 13 g06142865
Custom 4Up Display Menu Screens
Reset 4UP Display
The Reset 4UP Display feature allows the user to reset the organization of the aftertreatment parameters on the 4 Up display back to factory settings.
From the main menu screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector is in the "Display Settings" category.
Press the ENTER button (button 5) to enter the "Display Settings" Menu
From the Display Settings screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector is in the "Reset 4Up Display" category.
Press the ENTER button (button 5).
Illustration 14 g06142875
Reset 4Up Menu Screens
Units
The Units of the displayed parameters can be changed to either US or Metric (kPa).
From the main menu screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector triangle is in the "Units" category.
Press the ENTER button (button 5) – Will toggle between "US" and "Metric" units options.
Illustration 15 g06142891
Units Menu Screens
Logged Diagnostics
The purpose of this function is to provide a list of logged diagnostic for J1939 errors. Logged diagnostics will be accessible through the main menu for viewing after they have been acknowledged.Note: Only diagnostics from the Aftertreatment ECM (SA 0x91 hexadecimal) will cause an alarm on the display, however if a diagnostic from the engine ECM (SA 0x0 hexadecimal) has been detected. The code will also be populated after an Aftertreatment diagnostic has triggered an alarm. Diagnostics from both source addresses will display in the "Logged Diagnostics" screen.
From the main menu screen, use the LEFT and RIGHT arrow buttons (buttons 3 and 4) to scroll through the menu until the selector is in the "Logged Diagnostics" category.
Press the ENTER button (button 5).
Illustration 16 g06142895
Logged Diagnostic Menu Screens
When accessing the logged diagnostics from the main menu, the display controls