EDGE 1486915 - Caterpillar

Illustration 1 g01522161
206-1642 Parking Brake Control Gp
Illustration 2 g02811756
Detailed view of area A
Table 1
Specification for 206-1642 Parking Brake Control Gp    
Item     Qty     Part     Specification Description    
C     -     -     The dimension is measured with the handle (1) in the ENGAGED position. This adjustment is an initial adjustment.    
Distance from bottom surface of the 389-7167 Hand Control Lever Gp to the set location of the 039-9133 Pin is 120.0 3.0 mm (4.72 0.12 inch).
Illustration 3 g02811758
Detailed view of area B
Table 2
Specification for 206-1642 Parking Brake Control Gp    
Item     Qty     Part     Specification Description    
2     2     4L-6454 Bolt     Torque to
38.25 to 50.00 N m (28.21 to 36.88 lb ft).    
3     -     -     Maximum rotation of the brake assembly lever is 45 degrees.     259-0127 Hydraulic Caliper Brake Gp
Illustration 4 g02811759
Table 3
Specification for 259-0127 Mechanical Caliper Parking Brake Gp    
Item     Qty     Part     Specification Description    
D     -     -     Dimension between the jam nuts and the sleeves is
0.51 to 1.52 mm (0.020 to 0.060 inch).    
4     2     -     Before assembly, apply Loctite 542 to the threads.
Torque the nuts to
102 to 115 N m (75 to 85 lb ft).    
5     1     7X-3374 Full Nut     Use the following procedure in order to tighten the nut (6) :
1. Tighten the nut (5) to
13 to 14 N m (115 to 125 lb in).
2. Loosen the nut (5) by 3/4 of a turn.
3. Tighten the nut (6) against nut (5) to
61 to 75 N m (45 to 55 lb ft).    
6     1     1B-4430 Jam Nut    
Illustration 5 g02811760
Table 4
Specification for 259-0127 Mechanical Caliper Parking Brake Gp    
Item     Qty     Part     Specification Description    
-     -     -     Use the following procedure in order to adjust the brake assembly on the axle before installing on the frame:    
The handle (1) must be in the DISENGAGED position and the brake assembly lever (3) must be in the horizontal position in order to tighten the nut (5) .
1. Loosen the nut (5) and the nut (6) .
2. Tighten the nut (5) to
12 2 N m (106 18 lb in).
3. Loosen the nut (5) by counterclockwise for 5/6 turn and check that the disc is free to move.
4. Tighten the nut (6) against the inner nut (5) for locking the adjusting nut to
60 to 75 N m (44 to 55 lb ft)