EDGE 1545078 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
C     5P-0960     Grease Cartridge     1    
D     276-8833     Pin Driver Cap     1    
E     276-8834     Pin Driver Cap     1    
Check the condition of the O-ring seals. If the O-ring seals are damaged, use new parts for replacement.
Illustration 1 g00890198
Illustration 2 g01197257
Note: Install flange (11) with alignment Pin (15) between the bolt Holes (16) .
Apply a thin coat of Tooling (C) on the outside machined surface of flange (11). Apply a thin coat of Tooling (C) in the bore of flange (11). Install flange (11) in the bucket.
Illustration 3 g00889666
Temporarily install the O-ring seals (Not Shown) on each flange of the bucket at the pin bore for the stick. Start the engine, and lower the stick into the bucket until the pin bores are in alignment with each other. Stop the engine.
Illustration 4 g01197258
Make sure that the threaded puller hole in the end of pin assembly (10) is clean. Apply a thin coat of Tooling (C) on pin assembly (10). Use a suitable lifting device to position bucket pin (10). The weight of bucket pin (10) is approximately 59 kg (130 lb). Use Tooling (D) and a suitable hammer to install bucket pin (10).
Illustration 5 g00890207
Install plate (13) with shims (12). Install bolts (12) and tighten the bolts evenly.
Move the bucket to one side until the bucket contacts the stick. Measure the clearance between the bucket and the stick at flange (11). Record this dimension. Add or remove shims (12) between plate (13) and flange (11) until Clearance (X) between the stick and the bucket is between 0.5 mm (0.02 inch) to 1.0 mm (0.04 inch) .
If shims were added or removed, reinstall plate (13). Install bolts (14). Tighten bolts (14) evenly.
Illustration 6 g00889682
Position plate (9) and install bolts (8) .
Illustration 7 g00884879
Slide O-ring seals (7) off the pin joints between the stick and the bucket and onto the flanges on the bucket.
Illustration 8 g00884729
Slide O-ring seals (3) off the pin joints between the bucket and link assembly (4) and onto the flanges of the bucket.
Illustration 9 g01197261
Make sure that the threaded puller hole in the end of pin assembly (6) is clean. Apply Tooling (C) to the surface of pin assembly (6). Use a suitable lifting device to position pin assembly (6). The weight of pin assembly (6) is approximately 75 kg (165 lb). Use Tooling (E) and a suitable hammer to install pin assembly (6) .
Illustration 10 g00884725
Position plate (2) and install bolts (1) .
Slide O-ring seals (3) over the pin joints between the bucket and link assembly.