EDGE GP-CUTTING 1547375 - Caterpillar

Removal Procedure
Note: Put identification marks on all hose assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Open the engine enclosure.
Slowly loosen the filler cap on top of the hydraulic tank in order to release the pressure in the hydraulic system.
Drain the hydraulic oil from the hydraulic tank into a suitable container. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change". The capacity of the hydraulic tank is 26 L (6.9 US gal).
Illustration 1 g01044485
Disconnect harness assemblies (2) .
Disconnect hose assemblies (3) .
Remove bolts (4) and remove vibratory valve (1) from the machine.
Illustration 2 g01044490
If necessary, remove nuts (11) and spacers (10). Remove bolts (12) and the spacers. Remove bracket assembly (9) and shim (13) from engine (5). Remove shims (6) and washer (7) from studs (8) .