EDGE-BOLT ON 2058227 - Caterpillar

Hot oil and components can cause personal injury.Do not allow hot oil or components to contact skin.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00690406The filter for the front pump drive is located on the right side of the articulation joint.
Illustration 2 g00541322
Use a strap type wrench to remove the filter. Dispose of the used filter properly.
Clean the filter mounting base. Make sure that all of the used gasket is removed from the filter mounting base.
Lubricate the gasket of the new filter element with clean hydraulic oil.
Install the new filter by hand. After the gasket contacts the filter mounting base, tighten the filter by an additional 3/4 turn.
Start the engine and run the engine at low idle. Inspect the system for leaks.
Stop the engine. Make any necessary repairs.