EDGE-CUTTING 2755923 - Caterpillar

Illustration 2 g03782521
Progress by end of step 6 (in black)
Terminate the opposite end of the black 16 AWG wire from Step 4 with the appropriate size ring terminal and attach to the master disconnect terminal lug that goes to the "Negative Battery Terminal" of the starter battery.
Cut a length of black 16 AWG wire approximately 250 mm (9.8 inch) long and terminate both ends with 8T-8729 Connector Pins .
Illustration 3 g03782525
Loop created to prevent losing Telematics disable connector
Loop the black wire from Step 7 around the wiring assembly and insert the pins into locations "1 and 2" of a 3E-3364 Receptacle to prevent losing the Receptacle when not connected.Note: The 3E-3364 Receptacle in 3 allows power to be removed from the Product Link system.
Connect the 3E-3364 Receptacle to the 155-2269 Connector Plug As in Step 3.
Cut a length of red 16 AWG wire of sufficient length to reach from Pro harness open-end wires to "Positive Battery Source".An example would be terminal location 101 on an XQ800.
Splice one end of the red 16 AWG wire from Step 10 to the 101-RD "+ Battery Input" wire coming from the Pro harness.
Splice the opposite end of the red 16 AWG wire from Step 10 to a 304-5284 Fuse Holder .Note: Do not insert fuse into the fuse holder at this time.
Cut a length of red 16 AWG wire of sufficient length to reach from 304-5284 Fuse Holder from Step 12 to the "Positive Battery Source" identified in Step 10.
Illustration 4 g03782527
9X-1056 Receptacle Terminal and 308-YL wire (1) Hole "1" (2) Hole "2" (3) 9X-1056 Receptacle Terminal (4) Hole "4" (5) Hole "5" (6) 308-YL wire
Insert the 308-YL "Switched Power" wire (6) from the Pro harness through hole "1" (1) of a 9X-1054 Connector Plug As and then terminate with a 9X-1056 Receptacle Terminal (3). Secure the receptacle terminal into hole "1" (1) .
Cut two identical lengths of red 16 AWG wire of sufficient length to reach from 9X-1054 Connector Plug As to "Positive Battery Source" in Step 10.
Illustration 5 g03782529
9X-1054 Connector Plug As and red 16 AWG wire (1) Hole "1" (2) Hole "2" (3) 9X-1056 Receptacle Terminal (4) Hole "4" (5) Hole "5"
Insert one red 16 AWG wire from Step 15 through hole "5" (5) of 9X-1054 Connector Plug As and then terminate with a 9X-1056 Receptacle Terminal (3). Secure the receptacle terminal into hole "5" (5) .
Insert the other red 16 AWG wire from Step 15 through hole "4" (4) of 9X-1054 Connector Plug As and then terminate with a 9X-1056 Receptacle Terminal (3). Secure the receptacle terminal into hole "4" (4) .
Take the other end of the two identical red 16 AWG wires from Step 15 and connect to "Positive Battery Source" identified in Step 10.
Cut a length of black 16 AWG wire of sufficient length to reach from 9X-1054 Connector Plug As to a "Negative Battery Source" on the Control ECMs side