EDGE-CUTTING 2967602 - Caterpillar

Use a suitable press to install shaft (23) into front mounting flange (21). Use Tooling (E) to install retaining ring (22) into front mounting flange (21).
Illustration 32 g06134105
Install lip seal (20) into front mounting flange (21)
Use Tooling (E) to install retaining ring (19) into front mounting flange (21).
Illustration 33 g06134104
Install bearing liners (18).
Illustration 34 g06134102
Install bearing assemblies (17) and slide (16) onto swashplate assembly (15).
Illustration 35 g06134099Note: Note the orientation of slide (16) for assembly purposes.
Install swashplate assembly (15). Use Tooling (H) to hold slide (16) in the upright position.
Illustration 36 g06134096
Illustration 37 g06134094
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spring (14) and washers (13) into barrel assembly (8).
Use Tooling (D) and a suitable press to compress spring (14). Install retaining ring (12).
Illustration 38 g06134090
Install spring assembly (11) and shim (10) into barrel assembly (8).
Illustration 39 g06133954
Install ball joint (9) onto barrel assembly (8).
Illustration 40 g06133950
Install retainer plate (7) and piston assemblies (6) into barrel assembly (8).
Illustration 41 g06133926
Use nylon string to install rotating assembly (4). Install O-ring seal (5).
Illustration 42 g06133924
Install port plate (3) into pump housing (1).Note: Use Tooling (H) to hold port plate (3) in place.
Illustration 43 g06133100
Illustration 44 g06133092
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Use Tooling (C) and a suitable lifting device to install pump housing (1) onto front mounting flange (21). Install bolts (2). Tighten bolts (2) to a torque of 100 10 N m (74 7 lb ft).End By:
Bench test the piston pump before use, refer to Bench Test Procedures, REHS9395, and follow the setting and testing procedures. Install the piston pump.