EDGE GP- 4697445 - Caterpillar

Illustration 1 g03362668
366-0168 Water Pump Gp
Table 1
Specification for 366-0227 Water Pump Gp
Item Qty Part Specification Description
1 1 246-3129 Pump Impeller Pump impeller should be flush with the shaft within −0.25 to 0.00 mm (−0.010 to 0.000 inch).
2 1 153-1256 Lip Type Seal Install the lip type seal with the primary lip toward the water pump drive gear. Press the oil seal with a press until the oil seal is flush with face of housing as shown. Do not install the lip type seal by hand.
3 1 336-2212 Water Pump Seal As Press the seal group onto the shaft until the cup is fully seated inside the pump housing.
4 1 361-8234 Water Pump Gear Press the gear until the gear is flush with the bearing.
5 1 203-3831 Cup Plug Maximum installation depth of the cup plug from the machined surface is 0.5 mm (0.02 inch). Orient the cup plug as shown, within 10 degrees.
6 - 246-3130 Water Pump Shaft Diameter of shaft over impeller end is 25.400 to 25.413 mm (1.0000 to 1.0005 inch).