EDGE AS-CUTTING 4E2482 - Caterpillar

Cut two wire tie-wraps (113) .
Illustration 46 g00306813
Remove bolt (114) from the clip. Remove nut (115) from the clip.
Illustration 47 g00306814
Photo taken from a point below the rear of the cab.
Remove two bolts (116) from shield (117) . Remove shield (117) from the cab.
Illustration 48 g00306815
Photo taken from a point below the cab.
Remove nut (118) , the lockwasher, and the bolt from the mount assembly.
Illustration 49 g00306816
Photo taken from a point below the cab.
Remove nut (119) , the lockwasher, and the bolt from the mount assembly.
Illustration 50 g00306817
Use a hoist and a suitable lifting device to tilt cab (120) away from the engine.
Illustration 51 g03657143
Illustration 52 g00306818
Use Tooling (A) or suitable cribbing under the support assembly in order to support the cab, as shown.
Illustration 53 g00306819
Remove nut (121) and disconnect control cable (122) . Remove bolt (123) from bracket (124) . Remove bracket (124) and control cable (122) from the engine.
Illustration 54 g00306820
Remove bolt (125) and clip (126) from the air compressor.
Illustration 55 g00306821
Loosen retaining nut (127) and disconnect hose (128) from the air compressor.
Illustration 56 g00306822
Remove four bolts (129) and the nuts from universal joint flange (130) . Disconnect the drive shaft from universal joint flange (130) .
Illustration 57 g00306843
Remove two bolts (131) and two washers (132) from the engine support.
Illustration 58 g00307823
Remove two bolts (133) and two washers (134) from the engine support.
Illustration 59 g03657165
Attach a hoist, and Tool (B) to lifting plates (135) . Carefully remove engine (136) from the machine. The engine weighs 850 kg (1874 lb).