EDGE-CUTTING 4T0731 - Caterpillar

(17)Transmission, Bevel Gear, Flywheel Clutch And Steering Clutch Compartments
1. Remove plug and allow oil to drain. 2. Remove cover and element. 3. Inspect cover seal. Install a new one if necessary. 4. Install new element, cover and drain plug. 5. Remove floor plate. Remove cover and spring. 6. Remove screen and magnets. Wash screen in clean solvent. Clean magnets with a stiff bristle brush or clean cloth. Do not drop or rap magnets. 7. Inspect seal. Install a new one if necessary. Install magnets, screen, spring and cover. 8. Check oil level. Oil level should be at FULL mark on gauge (engine running at low idle). 9. Add oil if necessary.(18)Fan Bearing
Lubricate 1 fitting.(19)Hydraulic Control Lever Linkage
Lubricate 1 fitting.(20)Tilt Cylinder Control Linkage
Lubricate 1 fitting.(21)Fan And Alternator Belts
1. Check condition of belts. Always install a matched set when belts need replacing. 2. Check adjustment. Correct adjustment allows 7/8 inch (22 mm) deflection. 3. Loosen mounting bolts and move alternator to adjust belts.(22)Steering Clutch Brakes
Check adjustment. Adjust brakes when pedal travel reaches 6 to 6-1/2 inches (150 to 165 mm). To Adjust:1. Remove guard and cover. 2. Turn adjusting screw in until tight. Back screw out 11/2 turns (9 clicks).Diesel Engine Crankcase
Engines Equipped With Spin-on Type Filters
The normal oil and oil filter change interval for naturally aspirated engines is every 500 service hours or 3 months. 1. Run engine long enough to warm the oil. Stop engine. Open drain valve. 2. Remove and discard filters. 3. Clean filter housing base. Be sure all of old filter gasket is removed. 4. Install filter.5. Tighten filter 1/2 turn after filter gasket touches filter housing base.6. Install crankcase drain plug. 7. Remove breather. Wash breather elements in clean solvent. 8. Inspect seal. Install new seal if necessary. Install breather. Tighten bolt to 10 2 lb. ft. (1,4 0,3 mkg). 9. Fill crankcase. See Refill Capacities. Install fill cap.10. Check oil level. Oil should be in safe starting range on engine stopped side of dipstick.11. Start engine and check oil level. Oil should be at FULL mark on engine running side of dipstick. Check for leaks.Engines Equipped With Cartridge-type Filters
The normal oil and oil filter change interval for naturally aspirated engines is every 500 service hours or 3 months. 1. Run engine long enough to warm the oil. Stop engine and open drain valve. 2. Remove filter drain plug. 3. Remove cover and old element. 4. Check cover seal. Install new seal if necessary.5. Install new element. Install filter cover and drain plug.6. Close drain valve. 7. Remove breather. Wash breather in clean solvent. 8. Check seal. Install breather. Tighten bolt to 10 2 lb. ft. (1,4 0,3 mkg). 9. Fill crankcase. See refill capacities.10. Check oil level. Oil should be in safe starting range on engine stopped side of dipstick.11. Start engine and check oil level. Oil should be at FULL mark on engine running side of dipstick. Check for leaks.