EDGE-CUTTING 5126333 - Caterpillar

Stopping the engine immediately after the engine has been working under load can result in overheating of SCR components.Refer to the Operation and Maintenance Manual, "Engine Stopping" procedure to allow the engine to cool and to prevent excessive temperatures in the turbocharger housing and the DEF injector.
Allow at least 2 minutes after shutting down the engine before you turn the battery disconnect switch to OFF. Disconnecting the battery power too soon will prevent purging of the DEF lines after the engine is shut down.
Emergency Inducement Override
This feature is active as shipped from the factory, but can be deactivated by your Cat dealer. More detailed information on activating, deactivating, or resetting override, may be available, contact your Cat dealer.Before you attempt the procedures documented in this Operation and Maintenance Manual, "Emergency Inducement Override", make sure that you have read and understand the information in this document.The United States Environmental Protection Agency ( US EPA) requires limiting of the engine speed and/or power in certain conditions. This limiting helps ensure proper functioning of the engine emission control system. The EPA allows the temporary disabling of these limits during a qualified emergency situation. The temporary disabling of emissions control is referred to as Inducement Emergency Override and must be reported to the US EPA. Per the US EPA the following conditions qualify for overriding the imitation of power and/or speed.
A significant direct or indirect risk to human life.Below are examples of direct verses indirect risks.Direct - An emission controls condition that inhibits performance of an engine being used to rescue a person from life-threatening situation.Indirect - An emission controls condition that inhibits performance of an engine being used to provide electrical power to a data center that routes 911 emergency response communications.The emissions-related derate can be disabled for up to 120 hours of engine operation. The temporary disabling of emissions-related derate is referred to as Emergency Inducement Override and must be reported to the US EPA. The override can only be reset by the engine manufacturer, Caterpillar®. A dealer can reset the override using Cat supplied passwords. Improper use of the override, and failure to report use of the override is prohibited under federal regulations. Such violation is subject to penalties by the US EPA. The maximum civil penalty is $3,750 per day of operation in violation.Override Overview
When an emergency situation occurs, initial activation of the override is allowed without input from Caterpillar. Prior to activation, the operator will be notified of the following on display : "EMERGENCY USE ONLY. SEE OWNERS MANUAL. PENALTIES APPLY FOR MISUSE." Upon activation, the check engine, and action lamps will also illuminate to alert the operator that the override is active. The override must be paused by the operator if the emergency ends before the 120 hours of override operation has expired. Pausing the override can be accomplished via