EDGE-CUTTING 5212874 - Caterpillar

start by:a) remove exhaust manifoldb) remove air inlet manifoldc) remove fuel injection linesd) remove fuel injection nozzles1. Remove the coolant from the cooling system. 2. Remove clamp (2) from water sleeves (1) in each cylinder head. Push the water sleeves into the timing gear cover with tool (A) and a screwdriver.3. Remove bolt (3) from the bracket on the dipstick tube. 4. Remove bolts (4) and stud (5) from the heads.
Make sure the fuel injection nozzles are removed before the cylinder heads are removed. The fuel injection nozzles go through the cylinder heads and the nozzle tips can be broken off if the nozzles are not removed from the heads.
5. Install tooling (B) and fasten a hoist. Remove bolts (7), cylinder head (6) and the gasket. The weight of the cylinder head is 120 lb. (54 kg).Install Cylinder Heads
1. Clean the contact surfaces of the cylinder head and cylinder block. Make sure the surfaces are clean and dry. Install a new cylinder head gasket. Clean the bore in the cylinder head for the water sleeves. Put oil on the seals on the water sleeves. 2. Install tooling (A) in the cylinder head. Fasten a hoist and put cylinder head (1) in position on the cylinder block. 3. Put engine oil on the bolt threads and install the bolts that hold the cylinder head in place. Tighten the bolts in the cylinder head according to the following procedure: a. Tighten bolts 1 through 18 in number sequence to 60 10 lb.ft. (80 14 N m).b. Tighten bolts 1 through 18 in number sequence to 110 5 lb.ft. (150 7 N m).c. Again tighten bolts 1 through 18 in number sequence to 110 5 lb.ft. (150 7 N m).d. Torque for head bolts 19 through 22 (tighten in number sequence to) 32 5 lb.ft. (43 7 N m). 4. Install water sleeve (3) into the cylinder head with tool (B) and a screwdriver.5. Install bolt (4) which holds the dipstick tube to the cylinder head. 6. Install clamp (5) on the water sleeves.7. Fill the cooling system with coolant to the correct level.end by:a) install fuel injection nozzlesb) install fuel injection linesc) install air inlet manifoldd) install exhaust manifoldDisassemble Cylinder Heads
start by:a) remove cylinder heads 1. Fasten a hoist and put the cylinder head in position on tool (A). Use adapter plates (1) from tooling (A) to hold the head in place. 2. Put the valve springs under compression with tool (C).3. Remove the locks from the valves.4. Remove tool (C), retainer, spring, washer and valve from the cylinder head. Put identification on the valve as to its location in the cylinder head. 5. Check the valve spring force with tool (B). For the correct spring force, see the subject VALVES in SPECIFICATIONS.6. Do Steps 2 through 5 for the remainder of the valves. 7. Remove the valve seat inserts with tooling (D). The valve guides are part of the cylinder head.