EDGE-CUTTING 5332590 - Caterpillar

Illustration 1 g01357600
Park the machine on level ground. Lower the bucket to the ground so that the stick is vertical.
Illustration 2 g01363143
(1) Bolts
(2) Washers
(3) Plate
Remove bolts (1), washers (2) and plate (3) from the top of the hydraulic tank.
Illustration 3 g01364171
Clean the area thoroughly around the screen cover in order to keep dirt out of the hydraulic tank.
Relieve remaining internal pressure from the hydraulic tank by loosening the filler plug. After remaining pressure is relieved, tighten the filler plug.
Illustration 4 g01364175
(4) Bolts
(5) Washers
(6) Cover
(7) Spring
(8) Screen
Remove bolts (4), washers (5) and cover (6). Note: Do not allow spring (7) to fall into the tank.
Remove spring (7) and screen (8). Note: Refer to Operation and Maintenance, "General Hazard Information" for information on containing fluid spillage.
Wash the screen in a clean nonflammable solvent. Allow the screen to dry. Inspect the screen. Replace the screen, if the screen is damaged.
Illustration 5 g01363676
(9) O-ring seal
(10) O-ring seal
Remove O-ring seal (9) from screen (8).
Inspect O-ring seals (9) and (10). Replace the O-ring seals if wear or damage is evident.
Install O-ring seal (9) on screen (8).
Install screen (8) and spring (7). Then install cover (6), washers (5), and bolts (4). Note: Make sure that the O-ring seals and the spring are properly positioned during installation.
Inspect the O-ring seal on the pressure cap for damage. Replace the O-ring, if necessary. Clean the pressure cap. Install the pressure cap.
Install plate (3) with bolts (1) and washers (2).