EDGE AS 5508875 - Caterpillar

Cooling System
Add Supplemental Coolant Additive
1. Open the rear access cover on the top side of hood. 2. Remove the radiator fill cap.3. Add .24 liters (1/2 pint) of Supplemental Coolant Additive.4. Install fill cap.5. Close and secure the access cover.Electric Air Compressor
Change the Air Filter
1. Open the rear access door on the left side. 2. Lift and remove the filter.3. Clean the filter base.4. Position the new filter on the base and push down to install.5. Close the access door.Final Drives
Check Oil Level
Final drive oil plugs are located on the back side of the roller frames. Remove the oil fill plug from each final drive. Maintain the oil level in each final drive to the bottom of the plug opening. Clean and install the plugs.Swing Drive
Check Oil Level
Plug is located behind boom. 1. Remove the oil fill plug.2. Maintain the oil level to the bottom of the plug opening.3. Clean and install the plug. Change the oil anytime the swing drive system has been overhauled.Batteries
Check Electrolyte Level
Tighten the battery retainers every 1000 hours on all batteries.Check the following at least every 1000 hours, and more often as conditions require:* Clean the top of the batteries with a clean cloth.* Keep the terminals clean and coated with petroleum jelly.At the proper charging rate, in a moderate climate, a battery should not require more than 30 cc (1 ounce) of water per cell per week. Check the cells weekly in extreme temperatures, cell water usage could be higher. 1. Open the rear access door on the left side of the machine.2. Clean the battery surface with a clean cloth. Keep the terminals clean and coated with petroleum jelly. Install the post cover after coating. 3. Inspect the electrolyte level in each battery cell, except maintenance free. Maintain the level to the bottom of the fill openings with distilled water. If distilled water is not available, use clean drinking water.4. Close the access door.Battery, Battery Cable or Disconnect Switch Replacement
When replacing batteries, battery cables, or the disconnect switch, use the following procedure:1. Turn off the start switch and all electrical loads (wipers, heater motors, etc.)2. Turn off (open) the disconnect switch and remove the key.3. Disconnect the cable that goes to the machine frame at the disconnect switch (one cable connects to frame and one to battery negative). Be sure the disconnect cable cannot contact the switch stud where it was just removed.4. Disconnect the negative battery cable terminal at the battery(s) that goes to the disconnect switch. Where four 12 volt batteries are involved, the negative side of two batteries must be disconnected.5. Proceed with necessary system repairs.6. Reverse steps two through four.