EDGE-CUTTING 6I6350 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 422-8733 Jack Stand 2 Start By:
Separate the track.
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00538695Note: Adjust the height of Tooling (A) so that there is enough clearance between the sprocket and track links for removal of the final drive and motor.
Raise the side of the machine and install Tooling (A) under the frame, as shown.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Illustration 2 g06140646
Remove bolts (1) and cover (2) from the rear of the undercarriage frame.
Illustration 3 g06140649
Disconnect hose assemblies (3).
Illustration 4 g06140652
Attach a suitable lifting device to final drive and travel motor (5). Remove bolts (4). Remove final drive and travel motor (5). The combined weight of final drive and the travel motor (5) is approximately 118 kg (260 lb).