EDGE AS-CUTTING 6W9879 - Caterpillar

PROBLEM
The existing hydraulic tank fill cap can leak on certain 216B3 and 226B3 Skid Steer Loaders and 247B3 Multi Terrain Loaders. If the existing cap leaks it will result in loss of hydraulic fluid running down the side of the tank.
AFFECTED PRODUCT
Model Identification Number
216B 3 CD300466-00470
226B 3 AS200481-00498
MWD07359-07362, 7364, 7366-7374, 7376-7391, 7393-7394, 7396-7399, 7401-7403, 7405-7407, 7409-7410, 7412-7415, 7417-7419, 7421-7483, 7485-7661, 7706, 7712, 7714, 7717, 7719-7720, 7723-7724, 7732, 7738, 7740-7741, 7743-7744, 7748, 7752-7753, 7755-7790, 7795-7802, 7805-7808, 7827-7828, 7830-7831, 7834-7835, 7837, 7841, 7843, 7870-7871, 7875-7877
SNA01899-01923
247B 3 KB300264-00316
TSL02674, 2676, 2678-2680, 2682, 2684, 2686, 2688, 2690-2736, 2738-2833, 2835-2836, 2838-2866, 2870, 2872-2876, 2889-2891, 2893-2898, 2911-2912, 2914-2915, 2917-2919
PARTS NEEDED
Qty
Part Number Description
1 1428937 CAP-HYDRAULIC
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 17% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
0-1500 hrs,
0-24 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 0.5-hour job
Note: Up to 0.5 hours may be required in a few job site applications but machines in inventory and rental fleets should not take more than 0.2 hours.
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
Rework Procedure
1. Check the cap for presence or absence of Date Code marking and Rework marking as show in Image1.1.1.
Image1.1.1
a. If no Date Code marking is present then cap is good, no further action is required.
b. If there is a Date Code and an X Rework mark then cap is good, no further action is required.
c. If there is a Date Code and NO Rework mark then replace with a new cap or
rework the existing cap by trimming the tab shown in Image1.2.1 to height of 5.84 +/-0.5 mm (0.23 +/-0.02 in).
Note: If using a new cap, confirm that it has acceptable markings as described in "a" or "b", and that tab height meets the requirements specified in "c" before installing on machine.
Image1.2.1