EDGE-CUTTING 7J2960 - Caterpillar

7J2960 EDGE-CUTTING Caterpillar parts 834G, 834H, 834K

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA7J2960
7J-2960
7J2960

Weight: 198 pounds 89 kg.

Information:

ABRASION RESISTANT MATERIAL N

BOLT HOLE SIZE 28 mm

CHAMFER EDGE

HOLE PATTERN CENTERLINE

HOLE SPACING 152.4 mm

LENGTH 951 mm

NUMBER OF HOLES 6

THICKNESS 40 mm

TUNGSTEN CARBIDE N

WIDTH 330 mm

Buy EDGE-CUTTING 7J2960 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL DOZER,

Show more prices Caterpillar parts

This part in 1 request: Show. This information for suppliers only!

#1330237 7J2960

2024-04-27

Compatible equipment models: 7J2960:

WHEEL DOZER 834G 834H 834K Caterpillar

Number on catalog scheme: 2

Caterpillar 7J2960 Parts scheme EDGE-CUTTING

For full view, you need register

Information:

Illustration 1 g00326429
Coolant temperature sensor (1) Connectors to module for pressure and for temperature.The resistance value of the sensor corresponds to the surrounding temperature. This test will require the sensor to be at room temperature.
Disconnect connectors (1) from the engine harness.
There is one electrical connection in each connector (1). Measure the resistance between connectors (1). Make sure that good contact is made between the connector pins.
Compare the measured resistance with the resistance that is listed in the following chart:
If the resistance values do not agree, check connectors (1) and repair any faulty connections. If connectors are okay, replace the coolant temperature sensor.
If the resistance values agree, check the connectors for the pressure sensor and the temperature sensor at the module. If the connectors are okay, replace the module.
Table 1
Room Temperature Resistance
°C (°F) ohms
20 (68) 12,215 to 12,780
21 (70) 11,680 to 12,215
22 (72) 11,170 to 11,680
23 (74) 10,685 to 11,170