EDGE 8E3581 - Caterpillar

Illustration 11 g01248826
Remove seal ring (28) from shaft (26).
Remove bearing (29) from shaft (26).
Remove bearing race (27) from the shaft, if necessary. Note: Bearing race (27) will be destroyed upon removal.
Illustration 12 g01248776
Remove the remaining bolts. Install Tooling (C) in impeller (30).
Install Tooling (E) and attach a suitable lifting device to the impeller. Tighten Tooling (C) evenly, and remove the impeller with the carrier. The weight of the impeller with the carrier is approximately 30 kg (65 lb).
Use care in disassembly of the torque converter, in order to avoid damage to the stator.
Illustration 13 g01248901
Remove bolts (31). Remove stator (32) from pins (33).
Illustration 14 g01249117
Illustration 15 g01248944
Use suitable blocks in order to support the torque converter assembly close to the center. Use Tooling (F) in order to remove carrier (34).
Remove seal ring (35) and pins (33).
Illustration 16 g01248957
Illustration 17 g01248960
Remove the bolts that fasten retainer (37) to impeller (30). Use Tooling (G) in order to remove retainer (37).
Remove dowel (38) from impeller (30).
Use Tooling (H) in order to remove carrier (36) with the bearing from impeller (30).
Illustration 18 g01248962
Remove bearing (39) from carrier (36).
Illustration 19 g01248965
Use Tooling (J) in order to remove retaining ring (40) from the output flange.
Remove turbine wheel (41) from housing (42) and from the output flange. Remove the spacer that is under turbine wheel (41).
Illustration 20 g01248969
Use two people in order to reposition housing (42). The weight of the housing (42) is approximately 35 kg (75 lb). Remove stop pins (43).
Compress retaining ring (44). Remove ring gear (45). Remove the retaining ring.
Illustration 21 g01248973
Install Tooling (C) in output flange (46). Tighten Tooling (C) evenly, and remove the output flange (46) and oil ring (47) from the housing.
Illustration 22 g01248975
Remove seal ring (50) from carrier (49) on output flange (46).
If necessary, use a chisel in order to break carrier (49). Remove the carrier. Note: If the carrier is removed, the component is destroyed.
Use Tooling (F) in order to remove two bearings (48) from output flange (46).
Illustration 23 g01248981
Remove bolts (49) and retainer (50) from housing (42).
Illustration 24 g01248983
Use Tooling (H) in order to remove bearing (51) from housing (42).