EDGE 9R4674 - Caterpillar

Illustration 1 g01136161
Schematic of the Auto Lube Pressure sensorThis diagnostic code is associated with the Auto Lube Pressure sensor. An FMI 03 indicates the machine ECM has determined the sensor output signal voltage is above normal. Possible causes for this diagnostic code are:
A failed sensor power supply.
A failed or disconnected sensor.
There is an open wire in the sensor circuit.
The sensor output signal is shorted to +battery.
The machine ECM may have failed, but is unlikely. Note: Poor connections are often the cause of a problem in electrical circuits. Before performing this procedure, inspect all the machine harnesses and connectors involved in the circuit. Make sure to verify that all of the connections in the circuit are clean, secure, and in good condition. Correct any problems found with any of the connections. Verify the diagnostic code CID 0379 FMI 03 is still active, before continuing with this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes now, but clear those diagnostic codes when the original diagnostic code has been corrected. System Response:This failure may cause the pump to indicate, constantly or intermittently, higher than normal pressure. Test Step 1. CHECK SENSOR POWER.
Turn the disconnect switch and the key start switch to the ON position.
Insert the Multimeter Probe leads into the back of the Auto Lube Pressure sensor connector and measure the voltage between contact 1 (wire 140-BU) and contact 2 (wire 200-BK).Expected Result:The voltage is System Voltage.Results:
YES - The voltage is System Voltage. The system voltage is correct. Go to Test Step 2.
NO - The voltage is NOT System Voltage. There is aSystem Voltage supply problem. Repair: Reference the complete Electrical Schematics for the machine and investigate the machine System Voltage problem. After correcting that problem, check if the diagnostic code CID 0379 FMI 03 is still active. If the CID 0379 FMI 03 code is still active, go to Test Step 2. Test Step 2. CHECK THE SENSOR.
Turn the disconnect switch and the key start switch to the OFF position.
Disconnect the machine harness connector from the Auto Lube Pressure sensor.
In the sensor harness connector, insert a jumper wire between the contact for wire H441-GN and the contact for wire 200-BK in the sensor harness connector.
Turn the disconnect switch and the key start switch to the ON position.
Observe the status of the CID 0379 FMI 03 diagnostic code. Expected Result:The CID 0379 FMI 03 code stays active. Results:
YES - The CID 0379 FMI 03 code stays active. The sensor is not the problem. Go to Test Step 3.
NO - The CID 0379 FMI 03 code is no longer active and has been replaced by another CID 0379 related code. The sensor has failed. Repair: Replace the sensor. The new sensor will need to be calibrated. Go to Test Step 5.Test Step 3. CHECK THE SENSOR CIRCUIT FOR AN OPEN.
Turn the key start switch and the disconnect switch to the OFF position.
The sensor harness connector stays disconnected.
The jumper wire stays in the harness connector
Disconnect both the