EDGE-CUTTING 9W4493 - Caterpillar

Illustration 1 g00573764
Schematic For Sensor Power SupplyNote: The procedures that are used to troubleshoot this diagnostic code may cause additional diagnostic codes to be generated. Find the cause and repair the cause of this diagnostic code before troubleshooting any new diagnostic codes.This diagnostic code is recorded when the Main Display Module reads the voltage of the sensor supply voltage circuit as above normal. Also, the diagnostic code is recorded when the Main Display Module is shorted to +battery.
Measure the Voltage at the Main Display Module.
Turn the "ECS" switch to the COOLDOWN/STOP position.
Use the 7X-1710 Multimeter Probe to measure the voltage at the Main Display Module from Contact 24 to Contact 2 (ground). Do not disconnect the harness from the Main Display Module.Expected Result: The voltage should be 8.0 0.5 DCV.Results:
OK - The voltage is 8.0 0.5 DCV. The sensor supply voltage is correct. If the SERV CODE indicator remains ON, replace the Main Display Module. For more information, see Testing And Adjusting, "Module - Replace".
Not OK - The voltage is not 8.0 0.5 DCV. The sensor supply voltage is not correct. Proceed to Step 2.
Disconnect The Sensors.
The "ECS" switch remains in the COOLDOWN/STOP position.
Disconnect all sensors and senders that receive +8 DCV from the Main Display Module.
Use the 7X-1710 Multimeter Probe to measure the voltage that is from connector contact 2 (ground) to contact 24 of the Main Display Module.Expected Result: The voltage should measure 8.0 0.5 DCV.Results:
OK - The voltage measures 8.0 0.5 DCV. The voltage is correct. One of the sensors or one of the senders has a problem. Individually reconnect each sensor and reconnect each sender while the voltage level is being monitored. The voltage should measure 8.0 0.5 DCV when each component is connected. If the voltage is not 8.0 0.5 DCV the sensor or the sender has a problem. Replace the sensor or replace the sender.
Not OK - The sensor supply voltage is not 8.0 0.5 DCV. The sensor supply voltage is not correct. Proceed to Step 3.
Check The Harness For A Short To +Battery.
Turn the "ECS" switch to the OFF/RESET position.
Disconnect all sensors and senders that receive +8 DCV from the Main Display Module.
Disconnect the engine harness from the Main Display Module.
At the engine harness connector for the Main Display Module, measure the resistance from connector contact 24 to contact 1 (+battery).Expected Results: The resistance should be greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The harness resistance is correct. The Main Display Module has a problem. Replace the Main Display Module. For more information, see Testing And Adjusting, "Module - Replace".
Not OK - The resistance is less than 5000 ohms. The engine harness has a problem. There is a short between ground and the sensor supply voltage circuit in the engine harness. Repair the engine harness or replace the engine harness.