EDGE GP-BIT & CUTTING 9W7041 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
B 5P-7301 Seal Locator(1) 1
5P-1733 Seal Locator As 1
C 5P-7309 Bolts(2) 2
5P-1737 Bolts 3
D 6V-6143 Seal Installer 1
E 9S-8858 Nut (Seal Installer) 1
F 4C-9500 Quick Cure Primer 1
G 4C-9507 Retaining Compound 1
(1) For use with larger locators on the crankshaft
(2) For use with larger locators on the crankshaft
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: The rear seal and the wear sleeve must be replaced at the same time. Once the seal and the wear sleeve are separated, these components cannot be used again. Refer to Special Instruction, SMHS8508, "Special Handling Information and Installation Instructions for Crankshaft Seal Groups that Have Hydrodynamic Grooves In the Sealing Lip" before the seal is serviced.
Illustration 1 g01076371Note: Do not use any type of lubricant during the installation of the crankshaft rear seal and wear sleeve.
Before installation of the crankshaft rear seal and the wear sleeve, inspect the crankshaft for scratches. Also, inspect the crankshaft for any distortion on the surface that may lead to an out of round condition. Use a polishing cloth to remove any imperfections on the crankshaft.
Use Tooling (F) to clean the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2).
Apply Tooling (G) to the outside diameter of crankshaft (3). Apply Tooling (G) to the inside diameter of wear sleeve (2).
Fasten Tooling (B) to crankshaft (3) with Tooling (C).
The front and rear seals and wear sleeves have different spiral grooves in the seal. Because of this type of design, the front seal group for an engine is different from the rear seal group. If a seal group is installed on the wrong end of the engine, oil can actually be taken out of the engine instead of moving oil back into the engine.
Note: Install the crankshaft rear seal with the arrow that shows the direction of crankshaft rotation toward the rear of the engine.
Position wear sleeve (2) and crankshaft rear seal (1) on Tooling (B). Install Tooling (D) on Tooling (B). Lubricate the face of the washer on Tooling (E). Install Tooling (E) on Tooling (B).
Tighten Tooling (E) until Tooling (D) contacts Tooling (B).
Remove Tooling (B), Tooling (C), Tooling (D), and Tooling (E). Check the crankshaft rear seal and the wear sleeve for the correct installation.End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".