EJECTOR 7D3637 - Caterpillar

Table 2
Contact Description J2(1)
No.(2) Function Type
1 Battery + (Switched) Power
2 Implement Shutoff SW Common (Pin2 Pole 1) Voltage
4 Auto Carry Diverter/Impl Lock/Pitch Regen Return Load Return Ground
5 Dual Tilt (Valve S2) Single Tilt Solenoid Current
6 Dual Tilt (Valve S1) Pitch Solenoid Voltage
7 Auto Carry Diverter Solenoid Current
8 Dual Tilt/PCO(RV) Solenoid Return Ground
9 Condenser MTR RLY Driver Voltage
20 Water Valve Actuator Voltage
22 Digital Return Ground
24 Blade Raise/Lower Position Sensor Voltage
25 Blade Tilt Position Sensor Voltage
26 Blade Pitch Position Sensor Voltage
27 Ripper Riase/Lwer/Winch In/Out / 3 Function Control 1 Sensor Voltage
32 Ripper In/Out/Winch In/Out / 3 Function Control 2 Sensor Voltage
38 Autorip N/C) Voltage
39 Autorip N/O) Voltage
40 Winch Spool In/Out Position Sensor Voltage
41 Winch Drum Clutch Release Position Sensor Voltage
44 Winch Low Speed Lock SW N/C Voltage
45 Winch Low Speed Lock SW N/O Voltage
46 Implement Shutoff SW (Pin 4Pole2) Voltage
47 Implement Shutoff SW (Pin 6 Pole2) Voltage
48 Right Cylinder Lift Position Sensor Voltage
49 Left Cylinder Lift Position Sensor Voltage
50 3RD Function Signal Voltage
58 Winch Lockout SW N/C Voltage
59 Winch Lockout SW N/O Voltage
61 Remote Mode Enable Switch to ground
64 CAN B+ Data Link
65 CAN B- Data Link
67 CAN A+ Data Link
68 CAN A- Data Link
(1) The ECM responds to an active input only when all the necessary conditions are satisfied.
(2) The connector contacts that are not listed are not used.