EJECTOR A 9J6719 - Caterpillar

Adjustments for the Transmission Clutch Pressure
If the pressure reading for each energized clutch is not within the values in Table 4, the transmission clutch solenoid modulating valve may need replaced. Should the pressure for each energized clutch not be within the values in Table 4 the pump pressure may need adjustment.ReferenceFor additional information about calibrating the transmission clutch solenoid modulating valves, refer to the Service Manual module Testing and Adjusting, "Fill Time for the Transmission Clutch - Calibrate" for the machine that is being serviced.ReferenceFor additional information about electrical system troubleshooting, refer to the Service Manual module Testing and Adjusting, "Troubleshooting Diagnostic Codes" for the machine that is being serviced.Test for the Lubrication Oil Pressure
Use the following procedure to check the pressure of the transmission lubrication oil.The pressure tap for the transmission lubrication oil is located on the right side of the machine under the cab behind an access panel. Refer to Illustration 5.
Perform the steps in the "Machine Set up" and then continue to the following steps.
Attach tooling (A) or (B) on pressure tap (9)