ELBOW 0007245 - Caterpillar

Removal Procedure
Start By:
Lower the rear bottom guard. Disassembly and Assembly, "Bottom Guard - Remove".Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be cleaned.
Illustration 1 g01192568
Disconnect hose assembly (1). Remove bolts (2) in order to remove drive shaft (3) .Installation Procedure
Illustration 2 g01192568
Position drive shaft (3) and install bolts (2). Connect hose assembly (1). Tighten eight bolts (2) to the required torque listed in the note below.Note: If bolts (2) are (3/8 inch), the required torque is 55 10 N m (41 7 lb ft). If bolts (2) are (1/2 inch), the required torque is 135 20 N m (100 15 lb ft).End By: Raise the rear bottom guard. Disassembly and Assembly, "Bottom Guard - Install".