ELBOW 0008689 - Caterpillar

Illustration 14 g01208332
Position compressor (25). Install bolt (23) and (26) (not shown). Install belt (22) to compressor (25). Connect harness assembly (24) .
Illustration 15 g01208329
Connect harness assembly (21) and plate assembly (20) .
Illustration 16 g01208327
Connect hoses (19) .
Illustration 17 g01208319
Install clips (18) .
Illustration 18 g01208314
Connect hose assembly (17). Connect duct (16) and hose assembly (15) .
Illustration 19 g01208309
Connect refrigerant dryer (14) .
Illustration 20 g01223998
Connect hose assembly (13) .
Illustration 21 g01208101
Connect hose assembly (12). Connect harness assembly (11) .
Illustration 22 g01208094
Attach Tooling (A) to hydraulic tank (1) .
Illustration 23 g01208107
Position steering and implement valve (3) and install bolt (9).
Illustration 24 g01208123
Install bolt (5). Rotate elbow (7) and connector (8) to bolt (5). Tighten nut (6) .
Illustration 25 g01208099
Illustration 26 g01208135
Remove Tooling (C). Install plate (9) .
Illustration 27 g01208098
Connect hose assemblies (4) .
Illustration 28 g01208096
Connect hose assemblies (2) .
Turn the battery disconnect switch to the ON position.
Fill the power train system with clean oil. Refer to the appropriate Operation and Maintenance Manual for the correct procedure.End By:
Install the drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Pump Coupling) - Remove and Install".
Remove the radiator guard. Refer to Disassembly and Assembly, "Radiator Guard - Install".