ELBOW 0008698 - Caterpillar

Illustration 1 g00825912
Note: Lubricate all seals with the lubricant that is being sealed. (1) Torque for three plugs ... 28 4 N m (21 3 lb ft) (2) For installation of 3/8 inch pilot lines, limit torque to 50 N m (37 lb ft) and/or hold the hose adapter with a wrench. (3) (4) Two pilot cartridge valves (3) 194-5033 Pilot Cartridge Valve ... Dozer tilt (left) (4) 194-5033 Pilot Cartridge Valve ... Dozer tilt (right) (5) 157-2153 Spring Quantity ... four Length under test force ... 25.20 mm (0.99 inch) Test Force ... 24.0 1.7 N (5.40 0.38 lb) Free length after test ... 59.49 mm (2.34 inch) Outside Diameter ... 16.0 mm (0.630 inch) (6) 141-5151 Spring Quantity ... two Length under test force ... 23.9 mm (0.94 inch) Test Force ... 12.80 0.65 N (2.9 0.15 lb) Free length after test ... 26.51 mm (1.04 inch) Outside Diameter ... 7.3 mm (0.29 inch) (7) Torque for four cages (critical characteristic) ... 15 2 N m (133 18 lb in) (8) Torque for four orifices ... 2.5 0.5 N m (22 4 lb in) (9) 153-8926 Spring Quantity ... four Length under test force ... 8.0 mm (0.315 inch) Test Force ... 3.7 0.2 N (0.8 0.05 lb) Free length after test ... 10.58 mm (0.42 inch) Outside Diameter ... 4.2 mm (0.17 inch) (10) Torque for four stops ... 6 1 N m (53 9 lb in) (11) Use the required shims to adjust the position of the detent. (12) Distance between outer surface of plate and the edge of detent ... 1.75 0.2 mm (0.069 0.008 inch) (13) Plate that holds the detent in position (14) Position of the edge of the detent on the surface of the plate with the bulldozer in the float position (15) Detent for the Bulldozer Float position (16) Torque for four bolts (critical characteristic) ... 20 3 N m (180 25 lb in) (17) 194-5032 Pilot Cartridge Valve ... Dozer raise (18) When you assemble the lever, orient the lever. The bend of the lever should be 45 degrees one degree between the dozer tilt (left) and the dozer lower positions of the pilot valve. (19) 194-5032 Pilot Cartridge Valve ... Dozer lower, quick drop, and float (20) Torque for five plugs ... 12 3 N m (107 27 lb in) (21) For installation of 1/4 inch pilot lines, limit torque to 15 N m (133 lb in) and/or hold the hose adapter with a wrench. (22) Use an alignment tool to obtain a maximum of 1 degree (critical characteristic). Apply an adequate amount of grease to the moving surfaces. (23) Apply an adequate amount of grease to the moving surfaces. (24) Torque for two bolts that hold the detent ... 12 3 N m (106 26 lb