ELBOW 0016582 - Caterpillar

Illustration 22 g01036433
"Software Versions" Menu
Press the "OK/right reset" button in order to return to the "Diagnostics" menu.
Turn the "power/setup" switch to the ON position in order to return to the "Guidance" mode.Sensor Data
Use the "Sensor Data" menu in order to view the current sensor data that is generated by the system.
Inside the "Diagnostics" menu, toggle either the "right mast elevation/menu scroll" switch or the "left mast elevation/menu scroll" switch until "Sensor Data" is highlighted.
Press the "OK/right reset" button in order to select this item. A screen similar to Illustration 23 appears:The "Sensor Data" Screen shows each device that is detected. The "Sensor Data" Screen also shows the measurement for each device and the update rate for each measurement. If and EM400 is connected, position data is shown.
Illustration 23 g01346754
Observe the measurements for each sensor.
Press the "ESC/left reset" button in order to return to the Diagnostics menu.Fault History
The fault history menu shows the AccuGrade - Laser System faults.Note: The last five faults are stored. These faults can be retrieved even if power to the system is lost.In order to observe the fault history, perform the procedure that is listed here:
Inside the "Diagnostics" menu, toggle either the "right mast elevation/menu scroll" switch or the "left mast elevation/menu scroll" switch until "Fault History" is highlighted on the Display.
Press the "OK/right reset" button. A screen similar to Illustration 24 appears:
Illustration 24 g00994841
Toggle either the "right mast elevation/menu scroll" switch or the "left mast elevation/menu scroll" switch in order to scroll through the list of recorded system faults.
Press the "OK/right reset" button in order to access additional information about the highlighted fault. A screen similar to Illustration 25 appears:
Illustration 25 g01090562
Fault History screen (1) The device that caused the fault (2) The fault code (3) The fault count The fault count is the number of instances that a fault condition has been received from a particular device. (4) The time that the last fault condition occurred. (5) A description of the problem
Press the "ESC/left reset" button in order to return to the previous menu.
Press the "ESC/left reset" button in order to return to the Diagnostics menu.
Turn the "power/setup" switch to the ON position in order to return to the "Guidance" mode.Machine Voltage
The "Machine Voltage" menu shows the voltage that the system is receiving. In order to access the "Machine Voltage" menu complete the following steps:
Inside the "Diagnostics" menu, toggle either the "right mast elevation/menu scroll" switch or the "left mast elevation/menu scroll" switch until "Machine Voltage" is highlighted.
Press the "OK/right reset" button in order to select this item. A screen similar to Illustration 26 appears:
Illustration 26 g00994852
Observe the measured machine voltage. The machine voltage is shown in volts.
Press the "OK/right reset" button in order to return to the "Diagnostics" menu.
Turn the "power/setup" switch to the ON position in order to return to the "Guidance" mode.Test Control Box
The "Test Control Box" menu allows you to test the switches configured in the display for proper operation. The "Test Control Box" menu also allows you to test the display for proper