ELBOW 0065741 - Caterpillar

start by:a) remove flywheel housingb) remove camshaftc) remove oil pan plate 1. Remove the camshaft bearings from the cylinder block with tool group (A) and wrench (B). Start with the front bearing.Install Camshaft Bearings
TYPICAL EXAMPLE1. Install camshaft bearings (1) in the cylinder block. Start with the front bearing with tool group (A) and wrench (B). The bearings must be installed with the oil hole in each bearing in alignment with the oil holes in the cylinder block.2. The front and rear bearings must be .06 .02 in. (.15 0.5 mm) inside the ends of the cylinder block after installation.end by:a) install oil pan plateb) install camshaftc) install flywheel housing