ELBOW 0307945 - Caterpillar

Table 1
793C Trucks with HD Engines
New Part Number Part Name Former part Number Quantity
396-6003 Turbocharger Gp 376-6465 1
20R-7916 Turbocharger Gp 20R-1113 1
396--6000 Turbocharger Cartridge Gp 194-2974 1
20R-7919 Turbocharger Cartridge Gp 0R-7442 1
397-6397 V-Band Clamp 349-3361 1
396-6002 Turbine Housing 189-5121 1
Table 2
793D / 793B with HD Retrofit Engines
New Part Number Part Name Former Part Number Quantity
396-6006 Turbocharger Gp 376-6453 1
20R-7915 Turbocharger Gp 20R-1112 1
396-6007 Turbocharger Cartridge Gp 337-1986 1
20R-7920 Turbocharger Cartridge Gp 10R-9493 1
396-6008 Turbine Housing 252-1799 1
397-6397 Turbine Clamp As 349-3361 1
Table 3
789C HAA Trucks
New Part Number Part Name Former Part Number Quantity
396-6009 Turbocharger Gp 384-5546 1
20R-7914 Turbocharger Gp 10R-9218 1
396-6000 Turbocharger Cartridge Gp 194-2974 1
20R-7919 Turbocharger Cartridge Gp 0R-7442 1
396-6008 Turbine Housing 252-1799 1
397-6397 Turbine Clamp As 349-3361 1
Illustration 2 g06254883
V-band section view
The new V-band clamp has both a thicker and wider V-band, along with a larger T-bolt. This clamp requires an increased torque compared with the former design.The new turbine housing has extra material removed to allow more clearance for the wider V-band clamp.
Illustration 3 g06254936
Center housing cross section
(4) Increased length of pilotThe length of the pilot of the new center housing, which supports the turbine housing, has been increased. Refer to Illustration 2.New Turbine Housing V-Band Clamp Torque Procedure
Note: The v-band clamp is considered a one time use only component and should be replaced if needed.Note: Do not retighten the v-band clamp after the engine has run.Note: Limit the run down speed of the nut for the v-band clamp to 60 rpm maximum to avoid galling the threads.
Apply Loctite® C5A Anti-Seize to the threads of the clamp.
Tighten the turbine housing v-band clamp to 20 N m (15 lb ft).
Tap lightly around the entire circumference of the clamp with a soft-faced hammer.
Tighten the clamp to 30 2 N m (22 1.5 lb ft).
Tap lightly around the entire circumference of the clamp with a soft-faced hammer.
Tighten the clamp to 30 2 N m (22 1.5 lb ft).