ELBOW GP-EXHAUST 1558536 - Caterpillar

Illustration 1 g01930758
Approximate dimensions are shown. Dimensions will vary depending on the configuration and the options. (A) 3.94 m (12 ft 11 inch) (B) 4.29 m (14 ft 1 inch) (C) 16.64 m (54 ft 7 inch)
Table 1
637G Wheel Tractor-Scraper    
Engine (Tractor)     C18 Acert Diesel Engine
RHX1-UP    
Engine (Scraper)     C9 Acert Diesel Engine
, THX1-UP    
Transmission (Tractor)     Eight speeds (forward)
One speed (reverse)
, MWK1-UP    
Transmission (Scraper)     Four speeds (forward)
One speed (reverse)
, CWE1-UP    Intended Use
This Wheel Tractor-Scraper is an earthmoving machine as described in ISO 6165:2001 and is classified as a scraper. This machine is used to cut, load, transport, and discharge material through a forward motion.Application/Configuration Restrictions
Push-pull operation is only allowed between two machines. Using more than two machines will cause damage to components such as the hitch, hitch pins, and other push-pull components.
Push-pull shall only be conducted with machine models from the same family. For example, a 637F and 637G is allowed, but not a 637G and 657G.
Push-pull operation shall be conducted so that only one machine is being pushed at a time or only one machine is being pulled at a time.
Push-pull operation shall be conducted when both machines are operating in a straight line, otherwise damage can occur to the machine.
Auger machines and elevated scrapers shall not be push loaded.The operator station is ROPS certified to a tractor only mass of 22000 kg (48400 lb) as tractor portion of tractor-scrapers per Table 1 of ISO 3471:1994. This excludes scraper weight and this weight excludes payload.For the maximum approved operating weight refer to the loaded weight in Operation and Maintenance Manual, "Rated Load".Maximum side grade operation without machine articulation is 59% grade.Note: The listed restriction assumes a machine operating perpendicular to a side grade, graded ground surface, nominal payload, homogeneous payload distribution in the bowl and operating on a dry, firm underfooting. Refer to the Operation and Maintenance Manual, "Slope Operation" for more information.Maximum side grade operation with machine articulation is 20% grade.Note: The listed restriction assumes a machine operating at a slow ground speed on a graded ground surface, nominal payload, homogeneous payload distribution in the bowl and operating on a dry, firm underfooting. Refer to the Operation and Maintenance Manual, "Slope Operation" for more information.Service brake holding capability on a grade is 25% grade.Note: The listed restriction assumes that the brake components are within working specifications, a graded ground surface, and a dry, firm underfooting. Evaluate the condition of the machine and the environment and use appropriate judgment to maintain control of the machine.Parking brake holding capability on a grade is 18% grade.Note: The listed restriction assumes that the brake components are within working specifications, a graded ground surface, and a dry, firm underfooting. Evaluate the condition of the machine and the environment and use appropriate judgment to maintain control of the machine.While descending on a grade