ELBOW AS 3048000 - Caterpillar

Assembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0510 Driver Gp 1
B 5P-9722 Seal Driver 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01358794
Illustration 2 g01359145
Tolerances
Use Tooling (A) and a suitable press to install hub (8) on shaft assembly (7).
Use Tooling (A) and a suitable press to install shaft (7) into housing (6). Install the shaft assembly until the bearing is flush with the housing.
Use Tooling (B) and a suitable press to install seal assembly (5) in housing (6). The operating Height (C) of seal assembly (5) is 12.19 0.13 mm (0.480 0.005 inch).
Use Tooling (A) and a suitable press to install impeller (4) onto shaft assembly (7). The operating height (D) of impeller (4) is 8.97 0.25 mm (0.350 0.010 inch).
Install new gasket (3).
Position cover (2) and install bolts (1).
Position pulley (9) and install bolts (10). The distance (E) from the inside groove of the water pump pulley to the face of the housing should be 136.40 0.300 mm (5.370 0.012 inch).
Refer to Specifications, "Water Pump" for the tolerances. End By:
Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".