ELBOW-EXHAUST 3711289 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on the hose assemblies for installation purposes. Plug the hose assemblies. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
Open the engine hood.
The hydraulic oil cooler is mounted on the radiator assembly.
Illustration 1 g00843495
Illustration 2 g00843498
Open latch (1) .
Illustration 3 g00843564
Remove bolt (2) and the washer.
Illustration 4 g00843565
Disconnect hose assemblies (3) and (5) .
Remove two bolts (4) and the washers. Carefully remove hydraulic oil cooler (6) .Installation Procedure
Illustration 5 g00843565
Install hydraulic oil cooler (6) .
Install two bolts (4) and the washers.
Connect hose assemblies (3) and (5) .
Illustration 6 g00843564
Install bolt (2) and the washer.
Illustration 7 g00843495
Close latch (1) .
Close the engine hood.
Fill the hydraulic tank to the proper level. Refer to Operation and Maintenance Manual, SEBU7459, "Hydraulic System Oil -Change" for the correct procedure.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".