ELBOW 6V4245 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repairs is performed.
Turn the fuel supply to the “OFF” position.
Illustration 1 g01630653
Remove bolt (2) and bolt (3). Remove fuel priming pump (1) from base (4).
Remove gasket (5) (not shown). Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01630653
Position a new gasket (5) (not shown) on base (4). Note: Ensure correct orientation of the gasket.
Position fuel priming pump (1) on base (4) and install bolt (2) and bolt (3). Tighten the 6mm bolt to a torque of 9 N m (80 lb in). Tighten the 8mm bolt to a torque of 22 N m (16 lb ft).
Turn the fuel supply to the “ON” position.
Remove the air from the fuel system. Refer to Operation and Maintenance Manual, "Fuel System - Prime".