ELBOW 7K3534 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     1P-1861     Retaining Ring Pliers     1    Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Illustration 1 g01139168
Install thrust plate (17) in housing (7) .
Illustration 2 g01139126
Install seal (16) and use Tooling (A) to install retaining ring (15) in end cover (10) .
Illustration 3 g01139118
Install seal (13) and backup ring (14) in end cover (10) .
Install O-ring seal (12) in end cover (10) .
Illustration 4 g01139106
Install end cover (10) and bolts (11) in housing (7) .
Illustration 5 g01139086
Install driven gear (9) and drive gear (8) in housing (7) .
Illustration 6 g01139062
Install thrust plate (6) in housing (7) .
Illustration 7 g01139055
Install seal (4) and backup ring (5) in end cover (2) .
Install O-ring seal (3) in end cover (2) .
Illustration 8 g01139019
Install end cover (2) and nuts (1) .End By: Install the fan drive gear pump. Refer to Disassembly and Assembly, "Gear Pump (Fan Drive) - Install".