ELBOW 8X8813 - Caterpillar

Configurations
Service > Configurations
Press "Payload"."Payload" will highlight in blue and the Payload Configuration menu pages will appear.Payload Configurations
Service > Configurations > Payload
Illustration 9 g06003595
Service Configuration screen
Press "Configurations"."Configurations" will highlight in blue and the "Configurations" page will appear.
Illustration 10 g06003606
Configurations screen
Press "Payload"."Payload" will highlight in blue and the "Payload" Configuration menu pages will appear.
Illustration 11 g06127956
Payload Configuration screen 1 (Service Mode)
Illustration 12 g06127959
Payload Configuration screen 2 (Service Mode)
Illustration 13 g06127953
Payload Configuration screen (Not in Service Mode)
Available Configurations
Illustration 14 g06003662
Printer Installation screen
The options in the Printer Installation screen are "Installed" or "Not Installed".
Auto Truck ID
Illustration 15 g06003664
Auto Truck ID Configuration screen
The options in the Auto Truck ID Configuration screen are "Enabled" and "Disabled".
Auto Material ID
Illustration 16 g06003672
Auto Material ID Configuration screen
The options in the Auto Material ID Configuration screen are Enabled and Disabled.
Scale Data Source
Illustration 17 g06127975
Scale Data Source screen
The options in the Scale Data Source screen are "Cat®" or "Other".For CPM to work, Scale data source needs to be set to CAT and CAT data source set to Enabled.
Cat® Scale
Illustration 18 g06127969
Cat® Scale screen
The options in the Cat® Scale screen are "Enabled" or "Disabled".
Cat® Scale Demo
Illustration 19 g06004917
Cat® Scale Demo screen
The options in the Cat® Scale Demo screen are "Installed" or "Not Installed".Configurations With Cat® Electronic Technician (Cat ET)
Payload Configuration
Overload Warnings
The overload warning feature notifies the operator when a payload measurement exceeds 116.5% of the Loader Bucket Payload Target Weight configured in Cat® Electronic Technician (Cat ET) . The feature can be enabled/disabled through Cat ET as well, and is disabled by default. If a low lift weight or scaled weight shows overloaded, and the machine has gone to reverse since digging, the operator will be notified via a pop-up. This fault is also sent off board into VisionLink® and logged on the machine. The system monitors for overload both in normal operating mode and in standby mode. (VisionLink is a trademark of Trimble Navigation Limited, registered in the United States and in other countries).The overload warning will be cleared when a low lift or scaled weight is below the threshold is generated.Reference: For information on how to determine an appropriate overload limit see Payload Policy, AEXQ1391-00, "Cat Medium Wheel Loader Payload Policy - K Series, M Series". This media can be found on the Cat Media Information Center (CMIC) at https://cmic.cat.com/cda/files/4726317/7/AEXQ1391-00_update.pdf