ELBOW 9V4465 - Caterpillar

Turbocharged Engine And Naturally Aspirated Engine
Illustration 1 g00579557
(1) LeverOn G3408 Engines that are turbocharged, the angle (A) is the following value. ... 26 5 degreesOn G3408 Engines that are naturally aspirated, the angle (A) is the following value. ... 10 5 degreesOn all G3412 Engines, the angle (A) is the following value. ... 26 5 degreesThe shaft is splined. The shaft does not require a pin. (2) Holes for mounting the carburetor control rod. Use the outer hole for G3408 Engines, and use the inner hole for G3412 Engines.
Illustration 2 g00579563
Illustration 3 g00579570
(4) Typical spacer (5) Control rod for the carburetor on G3408 Engines (6) Control rod for the carburetor on G3412 EnginesInstallation Of Lever
(1) Hold the governor control shaft in the shutoff position. (2) Install lever (2) and tighten lever (2) to the governor control shaft. Install this lever at the shutoff position angle. This shutoff position angle is shown in the illustration above.The bend in lever (2) must be in position (B) for nonelectric governors. The bend in lever (2) must be in position (C) for electric governors. Dimension (A) between lever (2) and the governor ... 4.3 0.5 mm (0.169 0.020 inch)Note: Assemble the control rod for the carburetor and the spacer (4) to the governor side of lever (2). No spacer is used on G3412 Engines that have electric governors.