ELECTRICAL GROUP - STEERING COLUMN 6R7532 - Caterpillar

Illustration 3 g01096817
Install bracket (39) to the transmission.
Apply Tooling (B) and then apply Tooling (C) to the threads of bolts (37) prior to installation. Install four bolts (37). Tighten bolts (37) to a torque of 240 40 N m (175 30 lb ft).
Install mount assembly (38), bolt (36) and the locknut to bracket (39).
Tighten the locknut to a torque of 460 60 N m (340 44 lb ft).
Repeat Step 8 through Step 11 to install the rear transmission support for the right side.
Illustration 4 g01096453
Connect hose assembly (30) to the drain assembly.
Illustration 5 g01096452
Connect hose assembly (29) to the transfer gear case.
Install screen housing (27) and four bolts (28) to the transfer gear case.
Connect hose assembly (26) to screen housing (27).
Illustration 6 g01096451
Install tube assembly (25).
Install clips (23) and (24).
Illustration 7 g01096450
Install hose assembly (22).
Illustration 8 g01096442
Connect hose assembly (20) to the transmission.
Connect electrical connector (21).
Illustration 9 g01147213
Connect hose assemblies (16), (17), (18) and (19) to the transmission.
Illustration 10 g01096437
Connect electrical connector (15).
Connect quick release couplings (13) and (14).
Illustration 11 g01147207
Install two lugs (12) to the rear frame.
Install the four bolts to two lugs (12).
Install cover (11) to the rear frame.
Illustration 12 g03881861
Install pressurizer (8) to the operator station.
Install four nuts, and washers (9) to pressurizer (8).
Install two bolts, nuts, and washers (7).
Connect electrical connector (10).
Illustration 13 g01096429
Install handrail (6) and four bolts (5) to the operator station.
Illustration 14 g01147206
Install crossbeam (3) and two bolts (4) to the rear frame.
Illustration 15 g01096427
Install covers (1) and (2).
Fill the transmission. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the transmission. Refer to Operation and Maintenance Manual, "Transmission Oil - Change" for the correct filling procedure.
Check the hydraulic system oil level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check". End By:
Install the rear drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rear) - Remove and Install".
Install the center drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Center) - Remove and Install".
Install the upper drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Upper) - Remove and Install".
Remove the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Remove and Install".