ELECTRONICS GP-MONITOR 2736395 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-7640 Stand 2
8S-7611 Tube 2
8S-7615 Pin 2
B 138-7574 Link Bracket 2
C 154-6184 Forcing Bolt (M 20) 2 Start By:
Separate the track assembly.
Remove the travel motor.
Illustration 1 g00489826Note: Adjust the height of Tooling (A) so that there is sufficient clearance between the sprocket and the track for the removal of the final drive.
Lift the side of the machine in order to install Tooling (A) under the frame, as shown.
Illustration 2 g00712767
Fasten Tooling (B) and a suitable lifting device to final drive (1), as shown. Put a slight lifting tension on the final drive.
Illustration 3 g00712737Note: Mark the orientation of bolt holes (2) for the travel motor for installation purposes.
Remove bolts (3) and the washers from the final drive.
Illustration 4 g00712749
Use Tooling (C) in order to remove the final drive from the frame.
Carefully remove final drive (1). The weight of final drive (1) and the sprocket is approximately 312 kg (688 lb).
Remove Tooling (C) from the frame.