ELECTRONICS GP-MONITOR 3375060 - Caterpillar

Push the release button on the buckle to release the seat belt. The seat belt will automatically retract into the retractor.Seat Belt Extension
When using retractable seat belts, do not use seat belt extensions, or personal injury or death can result.The retractor system may or may not lock up depending on the length of the extension and the size of the person. If the retractor does not lock up, the seat belt will not retain the person.
Caterpillar's recommendation for extending a retractable seat belt is replace it with a nonretractable belt. Longer seat belts and extensions are available, when the seat belt is not of sufficient length for the operator.Contact any Caterpillar dealer for longer seat belt and seat belt extensions information.Window Cleaning
Use commercially available window cleaning solutions to clean the windows. Lift latch (1) to slide the windows. Squeeze latch (2) to release window from the CLOSED position. Clean the outside of the rear window from the inside of the cab by removing the sliding section of the window. To clean the rear window from the inside, use the procedure that follows to remove that section of the rear window.1. Move the handle stop to the UP position by lifting at handle (1) and rotating counterclockwise until it is vertical.2. Move the section of the window that slides to the opening in upper window channel (2).3. Tilt the top of the window toward the inside of the cab and remove it.Cab Doors
The cab door on the right side serves as an alternate exit. Move the latch to lock or unlock the cab door from the inside.Open the door until it latches in the fully open position.Push the lever, to release the cab door from the fully open position.AM FM-MPX Radio (If Equipped)
(1) ON/OFF Switch/Volume Control - Turn this knob to the right (clockwise) to turn the radio or cassette player on. Turn the knob further to the right to increase volume. (2) Left/Right Balance Control - Pull this knob and turn it either to the right or left to adjust balance for equal volume between left and right speakers. (3) Nonfunctional Knob (4) Bass Control - Rotate this knob to the right to increase bass tone, to the left to decrease it. (5) Treble Control - Push and rotate this knob to the right to increase treble tone, to the left to decrease it. Rotate while pushing the knob in. (6) Auto Scan Tuning Switch - During radio operation, press this switch to scan and stop at each station for eight seconds. You may advance the Auto Scan Tuning either upwards or downward by operating the Manual Tuning Control. If the desired station is found, press the switch again. Auto Scan Tuning stops and the selected station remains. (7) AM/FM Band Selector - Each time this button is pushed, the selected radio band appears on the display panel. (8) Manual Tuning Control - To select a radio station manually, turn the knob to the right. The radio advances