ELECTRONICS GP-MONITOR 4619774 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the installation of new components due to normal wear and aging. The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Use fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance. Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.When Required
Engine Air Cleaner Element - Replace
Engine Oil Filter - Change
Overhaul Considerations
Throttle Control Valve - Check
Valve Stem Projection - Measure/Record
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Cooling System Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Fuel Filter Differential Pressure - Check
Walk-Around Inspection
Every 250 Service Hours
Battery Electrolyte Level - Check
Cooling System Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Initial 1000 Service Hours
Engine Mounts - Check
Engine Speed/Timing Sensor - Clean/Inspect
Valve Stem Projection - Measure/Record
Every 1000 Service Hours
Alternator - Inspect
Belts - Inspect/Adjust/Replace
Carburetor Air/Fuel Ratio - Check/Adjust
Crankshaft Vibration Damper - Inspect
Engine Crankcase Breather - Clean
Engine Oil - Change
Engine Oil Filter - Change
Engine Valve Lash and Bridge - Adjust
Gas Pressure Regulator Condensation - Drain
Hoses and Clamps - Inspect/Replace
Ignition System Spark Plugs - Inspect/Adjust/Replace
Ignition System Timing - Check/Adjust
Inlet Air System - Inspect
Radiator - Clean
Every 1000 Service Hours or 6 Weeks
Aftercooler Condensation - Drain
Every 2000 Service Hours
Actuator Control Linkage - Lubricate
Cooling System Coolant Sample (Level 2) - Obtain
Engine Speed/Timing Sensor - Clean/Inspect
Every 4000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Crankcase Blowby - Measure/Record
Cylinder Pressure - Measure/Record
Engine Mounts - Check
Engine Protective Devices - Check
Exhaust Bypass - Inspect
Starting Motor - Inspect
Water Pump - Inspect
Every 8000 Service Hours
Turbocharger - Inspect
Water Temperature Regulator - Replace
Between 9000 and 16 000 Service Hours
Overhaul (Top End)
Every 24 000 Service Hours or 3 Years
Cooling System Coolant (NGEC) - Change
Between 27 000 and 48 000 Service Hours
Overhaul (In-Frame)
Between 45 000 and 80 000 Service Hours
Overhaul (Major)